HOME

UNDERSTANDING ORGONE ENERGY

ORGONE PYRAMIDS, CONES AND MORE

THE BOVIS SCALE

PROFESSIONAL DOWSING PRODUCTS

DOWSING ROD INSTRUCTIONS

VIDEO: FINDING UNMARKED GRAVES

MY OTHER WEBSITE

 

THE BOVIS SCALE
How to Measure the Energy of an Object

Download and Print a Bovis Scale HERE

    The Bovis Scale (also known as the Life Force Index) is named after a French Researcher, Anton Bovis, who studied the Earth energies of the Great Pyramids in the 1930's. This scale is used to measure Natural Earth Energies with ranges running from zero to infinity.
     To make it simple, the Bovis Scale measures positive and negative energy. If the object being measured is from 0 to 6,500, this is considered the negative range which means the object is giving off negative energy that IS NOT good for you. If the object being measured shows a range of 6,500 and above, the object is giving off positive energy that IS good for you. Obviously, the higher the number is on the positive scale, the better the energy is for you.

     The scale you see below uses the K numbers to represent 1,000 units of energy, so 1K would be 1,000 units of energy, 2K would be 2,000 units of energy, and so on. If you use this chart and you want to base your energy measurements on the 0 to 6,500 as negative and anything above that as positive, you can see the line between 6K and 7K on the chart labeled "Bovis Neutral Reference". From 0 to this line would be your negative energy reading. Anything above that line would be positive energy. For the purposes of the instruction below, you only need to pay attention to the numbers surrounding this chart.

Click on Chart to Enlarge

HOW TO MEASURE THE ENERGY OF AN OBJECT USING THE BOVIS SCALE

To measure the energy of any object or of an Orgone pyramid, cone or heart purchased from this site, you need the object, this chart, and a pendulum. If you don't own a pendulum, you can easily use a necklace, keychain or even a washer on a string. It just needs to be able to dangle down and move about freely. Once you find your pendulum, you will want to let it tell you how to determine "yes" and "no". This only needs to be done once as what it gives you for "yes" and "no" will always be the movements you will have for "yes" and "no".

Hold your pendulum, by one end, out in front of you. Make sure that the end you are not holding is able to swing freely. Ask it to show you the movement for "yes". Don't try to help it, just be patient and it will begin to swing for you. This could be back and forth, in a circle, etc. Whatever it does, remember that this is the movement for "yes". Do the same process for "no". These two movements have to be different to allow you to get correct readings from your Bovis Chart.

Print out the Bovis Chart from the link at the top of this page. Place the chart in front of you and place the object in the center circle on the chart. Place your pendulum above the object and ask it to show you the energy that is being given off by the object. Be patient. Your pendulum will most likely begin to swing back and forth between two different measurements. Make note of these measurements and move your pendulum to the first one, asking if this is the correct measurement. If your pendulum swings "yes", then that is the energy the object is giving off. If it says "no", go to the other measurement and repeat your question. If it said no to the first one, then it should say "yes" to this measurement. If it doesn't, then start over in the middle and repeat the process until you receive a "yes" to a specific measurement. Remember, intention is very powerful, so only use your pendulum when you are in a good frame of mind.

Stoneman Energy Copyright 2014 ~ All Rights Reserved